Round newspaper casket box
Nowadays weaving of newspaper tubes is becoming increasingly popular. Lesson is not difficult enough, besides it is very fascinating and interesting. The cost of acquiring the source material is practically minimal, since everything that is required for the manufacture of a round casket made from newspaper tubes is absolutely everyone. For work you will need: • Old newspapers or newsprint. • Plain knife. • Thin needle. • • PVA glue. • • Food colors. • • Varnish • Brush for processing the finished product.
Step by step description the manufacture of caskets. 1. Directly weaving the box will be made of newspaper tubes, which will require approximately 200-220 pieces. In order to get a newspaper tube, you need a newspaper or magazine, using a conventional knife, to cut across the stripes, the width of which is about 5 cm.If you are planning tubules of darker colors, then you can use the newspaper. For tubes of light and bright colors, newsprint should be used, since letters may appear through painting.2. In order for the tubule to be long and neat, the needle should be used as thin as possible. On the edge of the newspaper strip fits the needle at an angle of 35-40 degrees. The smaller the angle, the thinner the tube. From thin tubes the product turns out to be more accurate and more gentle. Tightly pressing the edge of the paper to the spoke, you need to twist the tube. The remaining upper edge to lubricate with white glue and screw the tube to the end. Needle pull out. The tube is ready.3. For painting tubes you can use the stain and food dyes. To paint with a stain, just drop the tubes in the bottle with this solution and remove them immediately. Leave to dry in the fresh air for 3 hours. To paint the tubes with food dyes, it is necessary to dilute them according to the instructions and lower the tubes into the paint container for 5-7 seconds.Dry in a warm place until dry.4. To weave the bottom of the box you need 4 groups of tubes, 2 in each, put a cross - over each other. These tubes are called stanchions.5. Under the lowest group of tubes substitute 1 working tube and braid in turn each of the groups.6. In order to build up the work tube, it is necessary to fold one edge next in half and insert it into the work pipe. There is no need to glue with it.7. After 6-7 rows of weaving, the stanchions must be divided in such a way that 8 single (from 4 groups) are formed. Substitute, similarly to the first, another working tube. Next, the product weave "string".To do this, you need the first working tube to clasp the stanchion from above and the second from the bottom. The second riser is similar, only the tube that was on top will go down and the bottom up.
9. To weave the walls of the box, you need to raise the stanchions up. To do this, we start one stanchion from below under a nearby one and gently lift it upwards. The same work is done with the rest.
>img src="https://sdelaysam-svoimirukami.ru/images/1/1225-polnogo-vysyhaniya-obrezat.jpg" alt="cut to full drying" title="cut to full drying">16. The lid trudges exactly like a bottom. At the end, the bend is made.